フレームリレーの設定例3: IP、numbered、ダイナミックルーティング


                       +-------------+            +---------+
                       |             |------------| Router2 |
+---------+            |             | 192.168.4.2+---------+
| Router1 |------------| Frame Relay |
+---------+192.168.4.1 |             |            +---------+
                       |             |------------| Router3 |
                       +-------------+ 192.168.4.3+---------+


Router1:

ip lan address xxx.xxx.xxx.xxx
ip lan netmask xx
bri line 1 l64 (RT200iのみ)
pp line l64 (RT100iのみ)
pp select 1 (RT200iのみ)
pp select leased (RT100iのみ)
pp bind bri 1 (RT200iのみ)
pp encapsulation fr
ip pp local address 192.168.4.1
ip pp routing protocol rip2
ip pp rip connect send interval
pp enable 1 (RT200iのみ)
pp enable leased (RT100iのみ)

Router2:

ip lan address xxx.xxx.xxx.xxx
ip lan netmask xx
bri line 1 l64 (RT200iのみ)
pp line l64 (RT100iのみ)
pp select 1 (RT200iのみ)
pp select leased (RT100iのみ)
pp bind bri 1 (RT200iのみ)
pp encapsulation fr
ip pp local address 192.168.4.2
ip pp routing protocol rip2
ip pp rip connect send interval
pp enable 1 (RT200iのみ)
pp enable leased (RT100iのみ)

Router3:

ip lan address xxx.xxx.xxx.xxx
ip lan netmask xx
bri line 1 l64 (RT200iのみ)
pp line l64 (RT100iのみ)
pp select 1 (RT200iのみ)
pp select leased (RT100iのみ)
pp bind bri 1 (RT200iのみ)
pp encapsulation fr
ip pp local address 192.168.4.3
ip pp routing protocol rip2
ip pp rip connect send interval
pp enable 1 (RT200iのみ)
pp enable leased (RT100iのみ)


※ 他社との相互接続の可能性が高いが、相手がRIP2を聞かない場合はRIP1にして
   やる必要がある